Thread: Discussion Aurora model set ups/templates
View Single Post
Old Aug 28, 2011, 12:55 PM
Dirt-Torpedo is offline
Find More Posts by Dirt-Torpedo
...just an earth bound misfit
Dirt-Torpedo's Avatar
Joined Mar 2010
660 Posts
Phoenix Sim setup for 3D/scale (Heli or Plane)

A setup that works for scale and 3d planes and helis in the Phoenix RC flight simulator. The setup is a superset of my crusty old DX6i, so I can use either TX on Phoenix.

Ch1 THRO, Ch2 AILE, Ch3 ELEV, Ch4 RUDD, Ch5: GYRO/SMOKE, Ch6: PITC, Ch7: AUX1(GEAR), Ch8 AUX2(FLAPS)

Controls are as follows:

LS - Flaps

SW(A) - [0] landing gear down, [1] landing gear up

SW(F) - [0] high rates, [1] low rates

SW(G) - [1] COND "HOLD" - throttle cut for autorotations

SW(E) - [0] COND "Normal" - linear throttle curve, no smoke & rate mode gyro
......... - [1] COND "SMOKE/HH" - linear throttle curve, smoke & heading hold gyro
......... - [2] COND "IDLE UP" - flat throttle curve, heading hold & smoke
Dirt-Torpedo is offline Find More Posts by Dirt-Torpedo
Last edited by Dirt-Torpedo; Aug 28, 2011 at 05:51 PM. Reason: Forgot to mention flaps...
Reply With Quote