View Single Post
Old Aug 24, 2011, 01:52 PM
flypaper 2 is offline
Find More Posts by flypaper 2
Canadian Bacon
flypaper 2's Avatar
Kingston, Canada
Joined Jun 2004
14,610 Posts
Not very good pics so I hope they help. I put a black penline on the 1/32 ply halfmoon to show where the servo arm is. I never liked the links on the ends of the pushrods so, being I had to make them longer I put Z bends on both ends. I take the servo arm off to remove and install them. The V bend in the wire is to fine tune the length of the pushrod by moving the V closer or further apart with pliers. I do this with all my planes.In the rear view, you can see the difference in the throw.

Gord.
flypaper 2 is offline Find More Posts by flypaper 2
Reply With Quote