Thread: Discussion Walkera V400D02
View Single Post
Old Aug 22, 2011, 10:09 AM
Mitchie is offline
Find More Posts by Mitchie
Registered User
Mitchie's Avatar
Canada, QC, Gatineau
Joined Jan 2011
2,157 Posts
For those who don't speak computer translation,

gege said he used 2mm aluminum and a non ferrous band saw to make the pieces from non copy write material on the internet. He said it takes a little time but is not difficult (as opposed to the translation )
He says the most important part is the precision of the 90* holes for the tail motor.

and for kdean, the motor is the right one, as for the esc, his has only two wires on the signal side, not three (red & white), and that there are two models, so to be sure to order the correct one...
whew....
Mitchie is offline Find More Posts by Mitchie
Reply With Quote