View Single Post
Old Aug 16, 2011, 05:26 AM
northernmike is offline
Find More Posts by northernmike
Registered User
Joined May 2011
584 Posts
I was able to find this:



I would begin with ruling out the signal - try another channel on the system, or even better, a stand-alone servo driver if possible. I know very little about sailwinches but this is where I'd start troubleshooting. (after establishing good voltage and clean contacts of course)

Best of luck,

- Mike
northernmike is offline Find More Posts by northernmike
Last edited by northernmike; Aug 16, 2011 at 06:41 AM.
Reply With Quote