View Single Post
Old Aug 12, 2011, 11:47 PM
RCRobbie is offline
Find More Posts by RCRobbie
Registered User
Joined Jul 2011
28 Posts
Quote:
Originally Posted by Tom Frank View Post
A video of what you are talking about would help. If it's just waviness in the video, it's vibration caused. Balance the prop for starters. Even then, the motor rotor can be out of balance, but there should be certain motor speeds where the waviness pretty much disappears, and speeds where it is worse (e.g. WOT). Mount the camera securely to a portion of the plane that does not vibrate or oscillate in flight... the fuse is a good place usually. I use tape with a pad of bubble wrap between the camera and fuselage as a cushion. Velcro, by itself, can hold a motor with a lot of force to remove it, but is not necessarily good at holding the camera steady if there are vibrations in the power system.
Here is the video. The camera is being held on by velcro right behind the prop. Any other suggestions? Thanks!

PZ Trojan Onboard Video - Keychain Camera (7 min 48 sec)
RCRobbie is offline Find More Posts by RCRobbie
Last edited by RCRobbie; Aug 12, 2011 at 11:55 PM.