View Single Post
Old Aug 09, 2011, 03:18 PM
ICU is offline
ICU
Find More Posts by ICU
ICU
Check out my Shapeways Shop
ICU's Avatar
Dallas,Tx.
Joined Apr 2007
1,202 Posts
To me it sounds like the board changed the motor output setting. The AR6400 has the ability to run an external esc. I would try changing this option.

Copied directly form the manual:

To Change the Brushed Motor to Operate an Optional Brushless Motor ESC or Brushless to Brushed Motor Control
The AR6400 is capable of operating brushless motors with the use of an optional brushless ESC, please see the illustration below for instructions.
Sticks must be held in this position while the transmitter is on and the receiver is off.
1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position (see illustration)
4. Move Control sticks to the corresponding position to change between the available options (see illustration)
5. While holding this position, plug the battery into the receiver, power receiver
6. The LED on the receiver will go solid and within 5 seconds the LED will flash 3 times quickly,
indicating the option is now changed
7. Disconnect battery from receiver
8. Turn transmitter off

***The image show to use FULL THROTTLE and FULL LEFT RUDDER**

GL
ICU is offline Find More Posts by ICU
Reply With Quote