View Single Post
Old Aug 08, 2011, 08:23 PM
JThiessen is offline
Find More Posts by JThiessen
Registered User
Joined Jun 2005
4 Posts
Just wanted to post up a simple case that I came up with - these aren't Feathermerchants supplies, but size should be about the same. After many hours of thinking and trying different cases over several weeks, I finally picked up the one I had been stepping over (it was the last one I had to try). Its a Stanley open case (no inserts and no guides for inserts). Used a 7/16" piece of plywood on the bottom to firm up the case, 3 vertical 3/4" dividers, and a 3/4" top plate. I used a Radio Shack Single Pole Single Throw switch on the input line. Drilled a bunch of holes in both sides for ventillation - and two larger holes on the output side so I dont have to open the lid to run it. Only issue I've found is that my switch doesn't light up correctly - its red when its off, but no light when its on (should have a green light).
JThiessen is offline Find More Posts by JThiessen
Reply With Quote