View Single Post
Old Aug 06, 2011, 08:03 PM
SkyCadet is offline
Find More Posts by SkyCadet
Segelfliegen bedeutet Freiheit
SkyCadet's Avatar
Canada, MB, Winnipeg
Joined May 2010
1,083 Posts
Discussion
Pitts 12 15e construction underway!!!

My new Pitts 12 15e from e-Flite came in a few weeks ago, and I was awaiting the motor and a few additonal bits [sullivan wire kit, dubro tail wheel kit] to complete the build.

This will be initially a 3S, 3800mAh system with a 900Kv, 770W motor. I will be using a 60A ESC (Eflite) and 4x HS82MG servos (Hitec) for the controls. A AR500 full-range RX completes the ensemble. I have a TruTurn 2.25" aluminum spinner painted gloss back to match the scheme, and I plan to use a MAS 12x6x3-blade prop. (see pix)

Wings and Elevator were done about 10 days ago, and I am now finishing the build. First major mod is the battery tray lowering to accomodate larger batteries. I cut out the upper front spar and made one using 3/16" balsa. (see pix) It is the same hieght as the rear spar, to allow the tray to ride on both.

This will allow a longer new tray to fit into the plane and manage CG better.

I also used Weldbond white glue on the front inner wooden surfaces to strengthen them a bit without adding a lot of weight...

More pix to come as we continue the build!

Darren/SkyCadet
SkyCadet is offline Find More Posts by SkyCadet
RCG Plus Member
Last edited by SkyCadet; Aug 06, 2011 at 08:09 PM.
Reply With Quote