View Single Post
Old Aug 03, 2011, 03:39 AM
duypham11 is offline
Find More Posts by duypham11
Registered User
Joined Aug 2010
44 Posts
Thank a lot for the information.
I am building CP antennas.
I do not mean I powered the TX and RX and asked for the led there.
I just tested 2 poles of the female-RSA port of TX and RX if it connected or not.
I powered a led via the female-RSA port of TX and RX. With TX the led was not on and the RX the led went light and then it lowered and kept the light.
So, I saw that the TX, 2 poles are not connected together and the RX, 2 poles are connected. This is different. I asked is it normally or failure with something?
Is it failed with RX (I thought)?
But I still see the video with this system but the range is very nearly.

Thanks Nigel again,
Duy
duypham11 is offline Find More Posts by duypham11
Reply With Quote