So that the Hyperion adapter the 1S 6 parallel one here
and a FMA CP10 pigtail also shown in that post. Connect (solder) the red lead from the pigtail to the red lead on the Hyperion adapter and the black lead from the FMA pigtail to the Hyperion black lead.
Now you can charge up to 6 1S Lipolys at a time. If you charge 6ea. 160 mAh then that is the same as charging a single 960 mAh one so a 1A charge rate would be 1C.
Just make sure that all of the LiPolys have been discharged (flown) the same amout so the voltages are close. A couple of tenths of a volt ( 0.02)difference is fine but do not place discharged and fully charged ones in the adapter at the same time.