Thread: Discussion Japanes Ball Drone.
View Single Post
Old Jul 31, 2011, 08:02 PM
boredom.is.me is offline
Find More Posts by boredom.is.me
Micro Boat Forum Founder
boredom.is.me's Avatar
United States, GA, Buford
Joined Nov 2007
6,529 Posts
My ball will need one 24"x36" sheet and one 12"x36" sheet. It is a lot to cut out by hand.

I do not see the controls be difficult at all. You will not even need a gyro. The battery needs to be located as far down as possible. The battery would act as a natural stabilizer.

My design has a cage to the bottom. Meanwhile, the rest of the electronics could be mounted between the battery and the motor. The servos should be mounted right under the motor mount.
boredom.is.me is offline Find More Posts by boredom.is.me
Reply With Quote