Thread: Mini-Review Walkera V200D01 - Mini Review
View Single Post
Old Jul 26, 2011, 08:24 PM
2dmatt is offline
Find More Posts by 2dmatt
I haveno idea what I am doing
2dmatt's Avatar
United States, SC, Lexington
Joined Jun 2011
123 Posts
Quote:
Originally Posted by nese View Post
Tip noted, thanks. The pipe cutter is starting to look like the best solution for this. No need for power, no noise, no dust, no need to wear safety goggles.


Pipe cutter works good, that's what I used but you will have to flair the cut end back out. The pipe cutter will crimp it down as it cuts. I used a wire cutter to flair the end back out which in turn produced tiny metal shavings. I didn't do a good job of cleaning all of these tiny shavings out of the tube and some got lodged in between my swash ball and the swash plate which caused enough resistance to burn up my servo. So make sure you blow Everthing out really good with canned air or an air compressor. Food for thought...
2dmatt is offline Find More Posts by 2dmatt
Reply With Quote