Thread: Discussion Dynam Turbo Jet
View Single Post
Old Jul 18, 2011, 06:28 PM
AJ5000 is offline
Find More Posts by AJ5000
Foamy Pilot
AJ5000's Avatar
United States, CA
Joined Jun 2011
457 Posts
Quote:
Originally Posted by killer vtwin View Post
yea it happens when the blades spread out ,its not a welcomed thing but must stock fans do this ,sometimes they need to wear in and sometimes you can loosen the motor and center it better ,I will run em in with a three cell then pop in the 4s
I have seen others on this forum use the same wording "wear in" or "break in", so I was assuming that this was somewhat normal. I am assuming now that the fans are rubbing at higher speeds because they are not balanced.

Quote:
Originally Posted by skyhawk View Post
That's the biggest bunch of nonsense.

It happens because stock fans are not balanced they vibrate and the imballance is what causes the run and wear. Should not be a problem - however - if it's bad enough it can cause the blades to fail and spit them all out the back.
I have searched the forum and can not really find a way or method to properly balance a fan. Is there a tool I can buy to balance them? How do you do it?
AJ5000 is offline Find More Posts by AJ5000
Reply With Quote