View Single Post
Old Jul 13, 2011, 10:36 PM
TomC is online now
Find More Posts by TomC
Registered User
Gold Coast Coolangata, Australia
Joined Nov 2003
2,713 Posts

I've only had my PNP for a few weeks now and the only things I'd suggest;
- Check/tighten all motor mounting screws
- Replace the stock prop with a apc 12x6e (or 13x4e for a little slower flying speed) and make sure you properly balance these
- Use the fully threaded bolts for the wings and the shouldered ones on the elevator
- if your strip is a little lumpy/bumpy ditch the wheel pants and use larger 3 inch light weight wheels. You will need a couple of extra wheel collars to hold the whells on. I drilled out a couple of 3mm ones I had with a 9/64 inch drill bit.

These are the main things I've found out. So far I really love this plane and I'm sure you will too.

Tom C
TomC is online now Find More Posts by TomC
Reply With Quote