View Single Post
Old Jul 11, 2011, 04:56 PM
helicow is offline
Find More Posts by helicow
Gravity gets me down.
helicow's Avatar
USA, FL, Brooksville
Joined Jan 2008
1,459 Posts
Quote:
Originally Posted by krexken View Post
Typically only one setscrew will tighten down on a flat spot on the shaft. If the setscrew you removed is the one on the flat spot, I'd bet you can press it without too much of a problem....
Glad I tried this. I was able to press it out. I assume it wore off the end of the set screw, it only showed a gouge at the very end. I ran a file though it to be sure.

New shaft went on great. That little c-clip - got a little beat up in the process but seems to be holding on. They should provide one of these along wit the new shaft.


Thanks for the ideas...

Runs nice and smooth....at least I can now wait until they come back oin stock at HC.
helicow is offline Find More Posts by helicow
Reply With Quote