View Single Post
Old Jul 01, 2011, 09:57 AM
rc Roller is offline
Find More Posts by rc Roller
RC Roller
United States, MO, Branson
Joined Jun 2011
37 Posts
2 blade 11/4.7 on the 1000mm Corsair

Quote:
Originally Posted by PikeStaff View Post
The 11x4.7 will work just fine on that motor.... the stock 3-blade attached to it now is an 11x6. You are assured it won't tax the motor at all.

However. As regards the 1400mm Corsair - please go to either of those 2 threads to see what you will need for them, there. BTW, that one swings a 14" diameter prop.

..........And you will need a whole lot more than a "small mAh 4 cell" for her, too
about my 20th flight on this new prop (2 blade 11/4.7 on the 1000mm Corsair) haven't blown up the engine yet will let you know if any problems occur, also running a 2200mah with 30c ,yea in know a bit large for the compartment but I like the fly time which is still only about 13 min then it is down to about 11.3 volts by end of flight. I still use the 1300mah for battery but I only get about 8 min out of it before it is down to 11.3 volts

I have read that I can push a battery down to 11.1 volts but where is engine cut off on this plane? hate to find out the hard way and go tree climbing

rc roller
rc Roller is offline Find More Posts by rc Roller
Reply With Quote