View Single Post
Old Jun 24, 2011, 07:35 AM
romihensem is offline
Find More Posts by romihensem
Flyboys Singapore
romihensem's Avatar
Singapore
Joined Aug 2008
84 Posts
hmmm

after 3 days of 2 hrs each trying to fix the gear doors mechanism, i have finally given up and set on just baring it open. i have come to a conclusion for me that i either need a higher torque servo for the retracts or by adding additional servo for the door which both i opted out of.

btw, need yr kind assist on a question. i'm now using 3 servos for my retracts, 2 for ailerons, 1 for elevator and 1 for steering. do i need a separate bec for this setup? i know that anything more than 4 servos recommends u to use a bec but i'm not sure do i need one since the 3 retracts servos will not be used often. basically just to on and off....
romihensem is offline Find More Posts by romihensem
Reply With Quote