View Single Post
Old Jun 21, 2011, 06:12 PM
Tom Frank is offline
Find More Posts by Tom Frank
Dance the skies...
Tom Frank's Avatar
United States, MA, Walpole
Joined Dec 2003
18,992 Posts
Quote:
Originally Posted by jmdlcar View Post
I think my lens is glued so what can I use to soften up the glue so I can adj the lens?
It's just hot melt adhesive. If there is not a lot of it, you might be able to pick it off with a small screwdriver like I did. But be careful you don't torque the lens housing without supporting it. Also, I had to remove the circuit board to get at the glue on the underside. Cover the circuit components with masking tape when you handle the circuit board... avoid touching any bare wires or solder pads.
Tom Frank is offline Find More Posts by Tom Frank