Thread: Discussion EVO Pro update
View Single Post
Old Jun 16, 2011, 03:43 PM
JimDrew is offline
Find More Posts by JimDrew
Xtreme Power Systems
Lake Havasu, AZ
Joined Jun 2005
16,934 Posts
Learned something new today! Our top mount adapter, designed for JR/Futaba cases works PEFECTLY with the EVO setup. The only problem is that you must snap the pigtail connector on to our board. Since these connectors have an insertion/removal life span of just 3 cycles before needing to be discarded, you would have to pay attention and snap on right the first time.

For the EVO you would need our top mount adapter and long pigtail.

We only sold a few thousands EVO and Profi upgrades, so its not a very big market compared to the other brands of radios that we support. I am still looking into this. It appears that the enable line is only needed during the initialization, so it might be possible to make an adapter that plugs between our board and the EVO connector to emulate the enable line based on the condition of the other two lines.
JimDrew is offline Find More Posts by JimDrew
RCG Plus Member
Last edited by JimDrew; Jun 16, 2011 at 03:49 PM.
Reply With Quote