: Build Log
Me-262 A-1a (Twin 90mm) by Airworld
View Single Post
Jun 16, 2011
, 02:46 PM
Irvine, Calif USA
Joined Feb 1999
I was also able to get a bit of work done on the motor/fan installation.
The fans fit perfectly in the nacelle opening, with no play. The front of the nacelle looks really solid, so that would be half of the motor mount.
The second half is a former that supports the fan assembly at the back. Then on the sides there will be two additional supports. Finally two ply braces will go from the rear former to the wing mount.
View all Images in thread