Originally Posted by timetec
Try this procedure (leave the cable attached
between the camera and the PC) :
Briefly press the rear button to switch the camera on as normal.
Usually, the yellow LED blinks twice before it enters standby or file transfer mode (as when connected to a PC).
As soon as the LED comes on for the first
time, press & hold
the front button down for 4 seconds - longer is OK.
Good luck all, Richard
Well, it worked once. Then the next two times I plugged the camera in, it worked without any special button pressing. But this morning, it's back to its old self and not even the button press between flashes will bring it up. Sadly, I give up and am sending it back.
The vendor, hxelepro360, has been very helpful and solicitous.