View Single Post
Old Jun 10, 2011, 12:05 PM
giuseppi is offline
Find More Posts by giuseppi
CV-15 VB-16
giuseppi's Avatar
USA, TX, Friendswood
Joined Jul 2007
1,436 Posts
Well I do believe I named this thread incorrectly. Should have called it "The Ever Evolving, Never Ending He-162 EDF Thread"

I've exceeded my AUW goal by about 150%. Paint must weigh a lot more than I considered. And since the Dollar Tree version @ around 100g wouldn't fly on the same power system it's time to consider an alternate power source.

So, out with the 30mm and in with the 40mm.

Going with this motor I purchased a few months ago :http://www.hobbyking.com/hobbyking/s...dProduct=14555 and a GWS 40mm EDF assembly.

Can't decide about the rotor. I have a 50mm that can be cut down. I believe the vanes are beefier than the 40mm rotors, and will flex less. Or just go with the 40mm rotor and bore the hole to fit the shaft. Any thoughts?

g
giuseppi is offline Find More Posts by giuseppi
Reply With Quote