View Single Post
Old Jun 04, 2011, 01:02 PM
OlliW is offline
Find More Posts by OlliW
Joined Sep 2009
2,925 Posts
@4712: nice that you are still with us here
The videos show that it works very stable so far.
äh, oh, I forgot to mention the weaknesses... I edited the above post accordingly... they might not very well be seen in the videos, but I think there is still room for improvement... but as a first step, it's not too bad either...

does the intoduction of the new Assan GA-250 gyro that is capable of running an analog servo change any of the design application here
as long as the hardware didn't change it doesn't matter, remember that you have to flash the uC with your software anyhow, so whatever the code was before it's going to be overwritten
OlliW is offline Find More Posts by OlliW