Thread: Discussion Multiplex Fun Cub
View Single Post
Old May 29, 2011, 06:19 AM
bubbleman is offline
Find More Posts by bubbleman
Registered User
bubbleman's Avatar
United States, TN, Cornersville
Joined Jan 2007
615 Posts
Quote:
Originally Posted by mbreslin View Post
How far did you guys extend the linkage cover/tubes toward the rear of the plane? Just long enough to fill the groove and the rest just the bare wire?

Thanks.
I had the same question. The instruction to "cut to length" with no length specified is lame.

I cut the outer sleeve to the point where the groove in the fuse side started to get shallow. The inner sleeve was cut so that it was as close to the elevator/rudder horn as possible without causing interference at full deflection.

When you get to the point of stickers on the sides, depending on how far back you put them, you will have to cut out the space between the bars to clear the rod assembly.

Anton
bubbleman is offline Find More Posts by bubbleman
Reply With Quote