View Single Post
Old May 26, 2011, 09:49 PM
3rdeyepro is offline
Find More Posts by 3rdeyepro
Hovership
3rdeyepro's Avatar
United States, CA, Cupertino
Joined Aug 2010
1,068 Posts
Quote:
Originally Posted by berkely View Post
Carefull with the diagrams David

It seems you have connected all gnd's from the ESC's together. It's better not to do so & avoid ground loops. Check this link on that topic if you want.

Regards
B.
So how do you do that? Just solder only signal pin for all motors (if I am using the regulator on the flyduino)?
3rdeyepro is offline Find More Posts by 3rdeyepro
Reply With Quote