Thread: New Product ESR / IR Meter fo Lipos
View Single Post
Old May 26, 2011, 03:06 AM
jaccies is offline
Find More Posts by jaccies
Registered User
The Netherlands, LI, Venray
Joined Dec 2008
1,461 Posts
Quote:
Originally Posted by Wayne Giles View Post
The Deans connectors are only there as a convenient way to insert and remove the calibration equipment. Actually a Deans connector is only about 2 - 3 milliohms, but the unit will measure everything such as soldered joints, wire etc so the difference between the total cell resistances and the pack reading will be about 6 milliohms. It does not affect the calibration readings as the inputs to the meter are feeding differential amplifiers; ie the circuit reads the voltage between the two cell connections, not the voltage above 0V.
The cell meter leads will only read up to a maximum voltage of about 4.8V although higher voltages (up to 20V) will not cause any damage, but the meter cannot read them.

Wayne
thanks , Wayne , that i can say i understand the explanation for 100% i have to say no , i am not an elecrial engineer , only i try to think logical
when i see 3 dean connectors in the circuit .
and the abbreviation CCT what does that mean ?
jaccies is offline Find More Posts by jaccies
Reply With Quote