Thread: Build Log Carbon Sally "Thepasty"
View Single Post
Old May 24, 2011, 11:51 AM
layer is offline
Find More Posts by layer
250Racers vs Toys Rus = Same!
layer's Avatar
Joined Apr 2007
508 Posts
Hy ZEN,

I do the long way around...

I cut 2 layers of transparent film for the lay ups, each side (top/bottom), spray them 3M77 and join them, this usually works for the LE curve, the two film layers in vacuum tend to micro move and adjust to the deformation.

The round tips I just cut them shorter and repaint later to achieve a good finnish on the LE also... (the film round corners are shorter than the foam round tips)
This way U don't have the tips all crunched at the corners...

I read somewhere that U can sand the Mylar and try to achieve that slight curve...?

Hope that helps?

LAYER
layer is offline Find More Posts by layer
Reply With Quote