View Single Post
Old May 23, 2011, 11:04 PM
3rdeyepro is offline
Find More Posts by 3rdeyepro
Hovership
3rdeyepro's Avatar
United States, CA, Cupertino
Joined Aug 2010
1,068 Posts
Is there any reason to take caution about the distance between the power distribution board and the sensor board? Will the power board give off noise that will mess with the sensors?

I am not using the connectors that came with the power board, just soldered my ESCs to the board to keep it all low profile. My sensor BOB will be sitting less than 10mm above this. Obviously being careful that nothing between the 2 boards touches.
3rdeyepro is offline Find More Posts by 3rdeyepro
Reply With Quote