View Single Post
Old May 10, 2011, 08:35 AM
n3m1s1s is offline
Find More Posts by n3m1s1s
Suspended Account
UK, Buckinghamshire, High Wycombe
Joined Feb 2007
4,133 Posts
ok so i think i flashed the 1.6 firmware to the blue board and things seemed to go a little t**s up then remembering i hadnt setup the gyro directions and throttle endpoints i went to rcexplorer for a quadcopter X mode setup and joy of joys after a few mins of reading and following the quad was flying (well doing a little hover over the bed) again with just the 1.6 software will relink up the helicommand soon

so if anyone by the blue kk board and gets abit stuck following minsoo kim's instructions try rcexplorer

got another quad prepped for the arduino too but it has servos on the back arms might have to remove them and angle 2 motors
n3m1s1s is offline Find More Posts by n3m1s1s
Reply With Quote  (Disabled)