View Single Post
Old May 08, 2011, 08:13 PM
deegola is offline
Find More Posts by deegola
~Lookout below!~
deegola's Avatar
Las Vegas, Nevada
Joined Jul 2004
128 Posts
OK, I think I am good on the (1) plane shown in picture.

I also adjusted the RX position in the Chipmunk. It has a fiberglass fuse.

I did notice I am getting little beeps sometimes when I am moving the control surfaces, but only with this airplane. When I stop moving the sticks, no beeps...then when I wiggle the sticks I get little super-short intermittent beeps?

What could that be?

PS - thanks for all your help so far
deegola is offline Find More Posts by deegola
Reply With Quote