Originally Posted by Buffythesaint
Does anyone know if there is a HexaX6 config file? I understand the hexa config file has the FC point to motor #1 and then you can move the red line between motors 1 and 2. My frame has the FC mount and point between 1 and 2. I don't think I can use the hexa config with the FC pointing between 1 and 2. It would still think it's pointing at 1. Couldn't find anything when I searched.
Maybe rotate the FC 90 degrees then adjust the line 90 degrees as well?? that should get it pointing between the two motors.
Or you could make your own mixer file.