Originally Posted by dowtort
I loaded the new software to my arduino, and moved the wires around to convert from nosaari's setup. I only tested channels 1-4, so startup took me a bit... had the aux switch in FM2 on power-up.
I power cycled and everything started up fine. I was in cramped space, so all i did was hover around in FM1 and yank the right (mode 2) stick around a bit.. response seemed less "digital". Can't wait to try it outside.
If the green light on the Arduino blinks 3 times at a one second rate, 'rx2atp' wants you to get your transmitter sticks and switches set to a configuration that it can start with. It waits for you to center the throttle stick and flip the flight mode switch to LAND.