View Single Post
Old Apr 09, 2011, 12:38 PM
Dennis C is offline
Find More Posts by Dennis C
Registered User
Dennis C's Avatar
Grass Valley California
Joined Jun 2004
2,472 Posts
Quote:
Originally Posted by mazjag View Post
Guys, I have got this thing and I love it, but have one small problem..I can`t get the elevator to trim properly. If my last move was a inside loop, it comes out and needs a click or two of down trim.. vise versa if it was outside..The servo is a new Hitec HS85mg..could it be this thing is not centering very well?? it looks fine on the ground and the linkage is ok. but something isn`t correct..I have tried a few different CGs....it just doesn`t track well pitch wise...thx..Jason
Check for any binding in the elevator hinges, and control linkage. if the quick links on the servo arm or control horn are to tight it will not center, same for any binding in the hinges. every thing should move with out any friction.

if every thing is free try switching servos just to make sure it is a servo problem.

Dennis
Dennis C is offline Find More Posts by Dennis C
Reply With Quote