Originally Posted by mazjag
Guys, I have got this thing and I love it, but have one small problem..I can`t get the elevator to trim properly. If my last move was a inside loop, it comes out and needs a click or two of down trim.. vise versa if it was outside..The servo is a new Hitec HS85mg..could it be this thing is not centering very well?? it looks fine on the ground and the linkage is ok. but something isn`t correct..I have tried a few different CGs....it just doesn`t track well pitch wise...thx..Jason
Swap it with an Aileron Servo and see if the problem moves or improves. Sounds like a bad servo, (If pushing the Elevator Pushrod by hand, disconnected from the Servo and the Elevator has No Binding) that is.