Thread: New Product ARF LotusRC T580 quadcopter
View Single Post
Old Apr 03, 2011, 08:16 PM
jesolins is offline
Find More Posts by jesolins
Tri-Quad-Hexa-Octo-copters!!
United States, TX, San Antonio
Joined Feb 2007
15,135 Posts
T580 baro foam 101

Gents,
See the attached photos of how I put some open cell foam over the baro for the T580. Simply split a 1in or 2.5cm square of open cel foam and slip it over the baro by gently lifting the baro and then pressing it down on the foam. Note, when you replace the FCB, make sure it is gently screwed down so it is level. Use a tiny bit of Lok-tie on the flight controller board(FCB) threads too. It is best to check the FCB's level with a spirit level but first always makie sure the model's prop plane is level. Adjusting these screws is likley how they calibrate the accelerometer without using a software setup calibration utility.
Cheers,
Jim
Quote:
Originally Posted by wolfes1126 View Post
Maybe have a Picture of it been done ?
So PPL can actually see what you mean if they dont know yet...
Quote:
Originally Posted by borneobear View Post
What foam shrink fit on the MPX trick?
jesolins is offline Find More Posts by jesolins
Last edited by jesolins; Apr 04, 2011 at 11:40 AM.