Radical RC Stick 400 Build Thread~~~Now with Video
View Single Post
Apr 03, 2011
, 02:54 AM
Joined Jun 2002
Now take the TE and line up the notches on the TE with the rib tails. They should in easily but be careful, thats a thin point. Also note, the ribs should slip in all the way and seat nicely. Its a common mistake to not have them seated and messing up the wing. Also note at this point you should also install the ply wing eject ramp in the rear center section of the wing. Notice it is conspicously absent from my pictures. I installed it later but its much easier (and correct) to do it now.
View all Images in thread
Lining up the Trailing edge
The TE now seated flush against the rib tails. Make sure it seats flush and complete. Check before you glue it.
Wing section shaping up.
Note the ribs seated flush.
Last edited by Carnifax; Apr 06, 2011 at