View Single Post
Old Apr 02, 2011, 10:15 AM
Wayne Miller is offline
Find More Posts by Wayne Miller
Registered User
Canada, ON, Woodstock
Joined Feb 2004
23 Posts
Pictures and harness

Hi,

I took pictures of the final wiring and harness.

The harness has colored wires. The wiring diagram is located in the PDF file. The colors should make it easy to see where the wires go. I twisted the wires after the picture was taken.

I also used the previous suggestion of using the "right angle" 1/10 in. spacing male pin strip as shown in the picture. The pins were straightened and pushed through to give the extra length needed to go into the module. The female connector is standard 1/10 in. spacing.

The Aurora uses the same antenna as the Optic 6 72MHz.

Hopefully it will help someone else.

It is an easy project to do if you can solder.

Fly4Fun,

Wayne

PS: I notice the same drawings have been inserted into Post #1 now which will make it easier since everything is located in one place - I'm not sure about the PDF.
Wayne Miller is offline Find More Posts by Wayne Miller
Last edited by Wayne Miller; Apr 03, 2011 at 09:08 AM.
Reply With Quote