View Single Post
Old Apr 01, 2011, 04:14 PM
Ford_63 is offline
Find More Posts by Ford_63
Call me Mad Hatter
Ford_63's Avatar
Joined Jun 2007
427 Posts
Quote:
Originally Posted by jlepinske View Post
Can anyone point me to some alternate motor mounting methods? Needs to allow room around the can for a water cooling spiral.
The method I was planning on using since the motor fits snugly in the bottom is to use two beads of silicone caulking, it should hold it and easy to cut it out if needed. For water cooling I usually just run a copper tube over the top and put the hoses up to it and tape it down. Maybe not the greatest method but it's easy.
Ford_63 is offline Find More Posts by Ford_63
Reply With Quote