View Single Post
Old Mar 31, 2011, 03:57 AM
Roto Rob is online now
Find More Posts by Roto Rob
Registered User
Denver, CO
Joined Dec 2005
6,907 Posts
Started on a tooling plate today. Turned out fairly good so far. I did mess up a hole. I installed bolts under the plate, as alignment stops. I did it before drilling the top holes. I decided to change the top hole positions, and forgot about one of the holes in the bottom. So that hole ended up a little oval when it went into the hole underneath. A bolt still holds ok in it, so I'll fix it later.
Roto Rob is online now Find More Posts by Roto Rob
Reply With Quote