Thread: Discussion GMFC Foam cutting software
View Single Post
Old Mar 28, 2011, 11:48 PM
roger2525 is offline
Find More Posts by roger2525
Registered User
United States, CA, Poway
Joined Oct 2006
305 Posts
cutting problem

I am trying to get my cutter set up to work right. I get it all set to cut 40mm block perfect, but when I go to cut a taper 80mm on one side and 40mm on the other side both blocks come out 8 mm to big, when I change the kref setting then my straight cut is way off to small. I am open to any ideas.

Roger
roger2525 is offline Find More Posts by roger2525
RCG Plus Member
Reply With Quote