Thread: Discussion Blade MCP X - owner's thread
View Single Post
Old Mar 23, 2011, 03:41 PM
turboparker is offline
Find More Posts by turboparker
Gopher huntin' stick jockey
turboparker's Avatar
United States, MN, Minneapolis
Joined Jul 2009
13,961 Posts
Quote:
Originally Posted by sviking View Post
I just...can't...stop...ordering...stuff for the mCP X I don't even have yet! Should be here tomorrow, but I went ahead and ordered some 1 x 4 x 1.12mm Boca Bearings to replace the stock blade grip bearings. I want NO part of this blade slinging crap. I've used Boca Bearings for many years and never, ever had one fail, tighten up, get rough, etc. $12 with free shipping is cheap peace of mind...
+1

Ordered a couple sets of those last week just to have 'em on-hand. (EDIT: I ordered Boca's 1.5 x 4 x 1.12 mm bearings.)

I have always used Boca replacements when doing major overhauls on my RC engines. I used them in the motors, drivelines, and hubs on my RC cars back when I raced on & off-road electrics. I've also never had one fail or even get rough.

Joel
turboparker is offline Find More Posts by turboparker
Last edited by turboparker; Mar 23, 2011 at 05:00 PM. Reason: Updated info
Reply With Quote