View Single Post
Old Mar 17, 2011, 12:13 AM
The Don is offline
Find More Posts by The Don
Wonderfully Wicked
The Don's Avatar
Willoughby, Ohio
Joined Jan 2002
13,630 Posts
Here is how I get a 4AS 1300 lipo in. I made a tray from some hard 1/16" sheet about 4" x 2 ". Then glued 1/8 x 1/4" strip around the perimeter. Then cut the front open so the balsa try will install much easier (see photo). Then glued the tray in. The lipo fits perfectly in. Next will be putting the nose back together.

Don
The Don is offline Find More Posts by The Don
RCG Plus Member