View Single Post
Old Mar 13, 2011, 06:15 AM
george2 is offline
Find More Posts by george2
Registered User
Hungary
Joined Oct 2006
147 Posts
Quote:
Originally Posted by StormJunkie View Post
(which I think you have to do on all DX7's, but should be done prior to adjusting travels) then you would end up getting 30% MORE travel above the 48-50mm. This may not instantly create a problem, but over time could over work the servo.

As for the rest of the electrics in the plane, I have not had any problems or heard of many with the ESC or the RX. Someone did say they had the elevator servo dislodge from the RX theoretically because the RX is mounted upside down. I'm also pretty convinced that the breaking motor mounts and vibrations is due to a really crappy inconsistent eflite prop. They are next to impossible to properly balance in the hub and blades.
I"m flying the Yak by Futaba T10 and 6014 Rx.No Spektrum stuffs are allowed in my Hangar.I saw too much problems with that brand.
george2 is offline Find More Posts by george2
Reply With Quote