Thread: Discussion GMFC Foam cutting software
View Single Post
Old Mar 09, 2011, 06:34 AM
I_Can't_Fly is offline
Find More Posts by I_Can't_Fly
But I am learning
I_Can't_Fly's Avatar
USA, MD, Cumberland
Joined Apr 2008
1,057 Posts
Gilles, thanks for opening this up on RCGroups. Sometimes the Yahoo boards are hard to navigate.

I have a question/concern. When cutting intertwined panels, and using the "X" cut at the LE, the first cut exits the foam wrong. The first cut is the bottom surface of the upper core, but when it gets to the LE, it changes direction and the "X" cut is in the up direction (instead of following the LE trajectory down). I don't know how else to explain this, but has anyone seen this? Is it something I have done wrong?

Thanks, Brian P.
I_Can't_Fly is offline Find More Posts by I_Can't_Fly
Reply With Quote