View Single Post
Old Mar 04, 2011, 11:25 PM
brokeitagain is offline
Find More Posts by brokeitagain
Registered User
Joined Feb 2011
6 Posts
thanks Chuck....it turns out the wires were ok...I had to make the following adjustment that was opposite what your video had suggested:

Step 2, Setting up Flaps for Camber and Reflex
- contributed by "padair"

"On the rate, set position 0 to -50%
On the rate, set position 1 to -50%"
should read
"On the rate, set position 0 to +50%*
On the rate, set position 1 to +50%*"

This fixed the problem!
Thanks for your assistance, sir.

Greg
brokeitagain is offline Find More Posts by brokeitagain
Reply With Quote