View Single Post
Old Mar 04, 2011, 11:13 PM
JumpySticks is offline
Find More Posts by JumpySticks
Drifting off the reservation..
JumpySticks's Avatar
USA, LA, Broussard
Joined Jan 2011
2,296 Posts
Got the Goldn Rods in. Had to ream out the channel to make them flush to the fuselage.

There must be a bend in the channel where it dives under teh surface to go into the servo compartment. The inner rods slide like butter through the outer tube when installing them from the rear....until the last two inches. Then there is a little more resistance. It's much slippier than the wire rods, but not quite as smooth as I would like. Still, my servos will be much happier.
JumpySticks is offline Find More Posts by JumpySticks
Reply With Quote