View Single Post
Old Mar 04, 2011, 08:53 PM
UNGN is offline
Find More Posts by UNGN
Power Wheels Guru
UNGN's Avatar
Southlake, TX
Joined Jan 2008
7,327 Posts
Quote:
Originally Posted by slim1357 View Post
OK I searched this thread as best I could and cannot find a similar problem. I picked up a dx6i today and bound it to my Tandem. Within 10 seconds of flight I had no aileron control. There was a burnt/ozone smell coming from the board so I pulled the battery and started looking for the problem. What seems to happen is that when I put the battery in, the servo motor pulls the slider bit all the way down the track and it stays there. It wont move with input from either the dx6i or the stock rtf tx. With the battery out I can move the large gear and get the slider all the way up in the track. When I put power to the board though it pulls it all the way down and it stays there. Any chance I can swap the servo and fix it or does this sound like a 5 in 1 issue?
Sounds like a burnt FET. This is usually caused by plugging a battery in backwards.

A new 5:1 would be required.
UNGN is offline Find More Posts by UNGN
Reply With Quote