Thread: Discussion Walkera V400D02
View Single Post
Old Mar 03, 2011, 09:57 AM
kdean is offline
Find More Posts by kdean
BahamaHeli
kdean's Avatar
The Bahamas
Joined Dec 2010
3,835 Posts
Fixer-Upper (#3)

Spent a few hours putting the Turnigy mg servos in my #3 V400 re-build. (will post pics soon)

I did alot of adjusting to the upper frame, shaving down the whole rear section so the bigger servos would sit right.

I got the swash level, but the pitch looks a bit off. Once I get the blades on I can set the ball link rods to the right length.

I have to reverse the rx to fix the gyro, and I'm going find a way to put the esc under the frame instead of on the side.

Will keep you posted.......

kdean
kdean is offline Find More Posts by kdean
Reply With Quote