Guardian stabilization module for your OSD Pro - $54.99!
View Single Post
Mar 03, 2011
, 01:58 AM
Joined Nov 2003
Thanks for the feedback and kind words!
One suggestion, AHI seems a bit low in update / frame rate, would be nice if it were more "fluid".
Yes, right now the AHI line redraw rate is (arbitrarily) set to 10Hz. This is fine for "normal" FPV flying, but it can lag with aggressive flying. The stabilizer is updating much faster internally, of course. We'll increase the redraw rate in the next video we post.
So will this just plug into the elogger?
Yes, it just "daisy chains" with the OSD - eLogger bus. It can plug either into the eLogger, or the OSD (your preference).
Will this use existing control surface wiring attached to an installed OSD pro?
Correct, no additional wiring is needed.