Thread: Discussion Hitec Aurora 9 Transmitter
View Single Post
Old Feb 28, 2011, 01:53 PM
A.T. is offline
Find More Posts by A.T.
Registered User
Joined Aug 2002
5,811 Posts
Bezel Wrench for Transmitter Switches - DIY

Originally Posted by tom6696950 View Post
Hello guys i haven't posted hear in some time i just wanted to know if any of you have broken a switch on you A9 and if so how do i go about getting it fixed any info will help thanks Tom
Refer direct to Hitec Warranty & Service, in need, for a replacement switch.
An expensive little wrench, used for bezels etc on a number of electronics is available commercially.

A good quick DIY cheap wrench:
1. Buy a 12" piece of K&S #10-246 1/2" X 1/16" Brass strip.
2. Cut into 3 x 4" strips.
3. File a 6mm wide x 10mm long slot at end of each.
4. Bend last 6mm of prongs down at right angle, as per attached picture.

Alan T.
Alan's Hobby, Model & RC FAQ Web Links
(quick search = Ctrl+F)
A.T. is offline Find More Posts by A.T.
Reply With Quote